Servicing Maitland & the entire Hunter RegionMon–Fri 7am–5pm · Sat by appointment · (02) 4005 2903
(02) 4005 2903
Drone view of a light grey metal roof with new skylights after replacing old terracotta tiles in East Maitland, NSW

Light, air and comfort

Skylights, Roof Ventilation & Insulation in Maitland

Bring daylight into dark rooms and push heat out of the roof space with skylights, whirlybirds, roof vents and sarking, all properly flashed into your metal roof.

Maitland's January average maximum is 30.2°C, and it has hit 44.5°C on record, so a hot roof space makes the whole house harder to cool. Roof ventilation and sarking help keep heat out. Skylights bring natural light into hallways, bathrooms and living areas without adding windows.

Because every skylight and vent is a hole in your roof, the flashing has to be right. We're metal roofing specialists, so every penetration is flashed and sealed to suit your roof profile. These upgrades are often most cost-effective during a re-roof, but we install them on existing roofs too.

You might need this if…

  • The roof space is extremely hot in summer
  • Rooms or hallways are dark during the day
  • Condensation is dripping from under a metal roof
  • An old skylight is leaking or discoloured
  • You're re-roofing and want to add insulation

What's included

  • Advice on skylight type, size and placement
  • Skylight and tubular skylight installation
  • Whirlybird and roof vent installation
  • Sarking or insulation blanket during re-roofs
  • Flashing matched to your roof profile
  • Replacement of leaking or old skylights
  • Clean-up and final leak check

Before & after: skylights, ventilation & insulation jobs

Close-up of old orange terracotta roof tiles with lichen and worn ridge capping in East Maitland, NSWBefore
Drone view of a light grey metal roof with new skylights after replacing old terracotta tiles in East Maitland, NSWAfter
Old terracotta to light grey metal with skylights · East Maitland

Skylights and tubular skylights

A conventional skylight brings in a wide spread of light and can be fixed or ventilated. A tubular skylight uses a small roof opening and a reflective tube to light a hallway, bathroom or walk-in robe. Both need to be flashed to suit the sheet profile. Poor flashing is a common leak point, so this is where getting a roofer to do it pays off. We also check the framing below so the opening is properly supported and trimmed. If an existing skylight is leaking, we'll tell you whether new flashing will fix it or the whole unit should be replaced.

Whirlybirds and roof vents

Whirlybirds and other roof vents let hot air escape from the roof space, and they can help reduce condensation under metal roofs. Options range from simple wind-driven whirlybirds to solar or powered vents and, on some metal roofs, ridge vents. The right number and type depends on your roof size, shape and existing eave ventilation. Every vent is flashed into the sheet profile, so a vent installed by a roofer won't become your next leak. On a re-roof, it's easy to add vents at the same time.

Waterfront two-storey home with a dark metal roof and glass roof section overlooking the water in Salamander Bay, NSWLight grey metal roof with a skylight on a renovated country home in Paterson, NSWLong commercial building with a full new metal roof and roof ventilators seen from above in Rutherford, NSW

Sarking and insulation blankets

Sarking or a foil-faced insulation blanket under metal roofing reduces radiant heat, rain noise and condensation. It's easiest to install when the sheets are off during a re-roof. In bushfire-prone areas rated BAL-12.5 to BAL-40, fully sarking a metal roof is one of the AS 3959 options for keeping embers out. Combined with a light colour (BASIX classes solar absorptance below 0.475 as Light), it makes a real difference in summer.

Approvals for new roof openings

Like-for-like re-roofing is generally exempt development, but the NSW Codes SEPP exemption doesn't cover creating or resizing openings in the roof (Bannermans Lawyers). Check with Maitland City Council or a certifier before adding a skylight, especially in a Heritage Conservation Area. See our council approval guide.

How the job runs

  1. 1

    Talk it through

    Tell us which rooms are dark or hot, and we'll suggest options.

  2. 2

    Inspect and quote

    We check the roof, roof space and framing, then give you a written quote.

  3. 3

    Check approvals

    We flag anything that may need council or certifier sign-off.

  4. 4

    Install

    We cut in, frame, flash and seal each skylight or vent to suit your roof profile.

  5. 5

    Test and tidy

    We check for leaks, clean up and show you how everything works.

Skylight and ventilation cost guide

ItemGuide range
Skylight installed (Newcastle)$1,425–$3,800
Tubular skylight unit (national)$150–$1,200
Ventilated skylight installation (national)$1,200–$1,600
Whirlybird installed (ACT)$150–$300
Solar roof vent installed (ACT)$550–$1,000+
Sarking (per m²)$4–$10/m²

Sources: whatsthedamage.com.au's Newcastle guide (Sept 2026) for skylight installation; Yellow Pages (Nov 2025) for tubular and ventilated skylights; Rebel Roofing ACT (Dec 2025) for whirlybirds and solar vents; Airtasker (Jan 2026) for sarking. They're a guide only, not our quote. Source: whatsthedamage.com.au – Roofing cost Newcastle (Sept 2026).

Try the cost calculator

Who does this work

Our own licensed crew, not subcontractors. NSW Contractor Licence 463604C · ABN 56 672 449 964 · written contracts with a 10% maximum deposit · statutory 6-year/2-year warranties under the NSW Home Building Act. More about how we work.

Last reviewed

Guide · 6 min readChoosing a COLORBOND® roof colour: heat, BASIX and Hunter summersRoof colour changes how hot your house gets. Here's how solar absorptance, BASIX colour classes and Thermatech apply to a Maitland roof.

Skylights, Ventilation & Insulation FAQs

Will a skylight make my room hotter?
It can if it's oversized or poorly placed on a west-facing roof. Choosing the right size, glazing and position makes a big difference. Tubular skylights let in plenty of light through a small opening, so they add less heat. We'll talk through placement before you decide.
Do whirlybirds really work?
Whirlybirds let hot air escape from the roof space, which helps with summer heat and condensation. How much they help depends on roof size, eave ventilation and insulation. Several vents working with sarking or insulation generally do more than one vent on its own. We'll recommend a sensible number for your roof.
Why does my metal roof drip on cold mornings?
That's usually condensation. Warm, moist air from the house meets the cold underside of the sheet and condenses, especially in Maitland winters, when July's mean minimum is 5.5°C. Sarking or an insulation blanket and better roof-space ventilation are the usual fixes. Sealant won't help.
Can you replace an old leaking skylight?
Yes. Older skylights often leak at the flashing or have discoloured, brittle lenses. We remove the old unit, check the framing and install a new skylight with flashing that suits your roof profile. Airtasker's 2024 guide puts skylight flashing repairs alone at $300–$500 nationally, so replacement is sometimes the better value.
Is it cheaper to add sarking during a re-roof?
Yes. With the old sheets off, sarking or an insulation blanket can be laid straight over the battens without extra labour to lift and refit sheets. Airtasker's January 2026 guide puts sarking at $4–$10 per m². We include it as an option on every re-roof quote.
Do I need approval for a skylight?
Possibly. The Codes SEPP exemption for re-roofing doesn't cover creating new roof openings. Heritage items and homes in Heritage Conservation Areas generally need council consent for roof work. Check with Maitland City Council or a certifier before we install, and we'll build to whatever is approved.

Free quote

Book a free measure & quote

Tell us a little about the job and we'll call you back. Photos help — you can text them after we call.

  • NSW Contractor Licence 463604CCheck it on Service NSW
  • Written contract, 10% max depositAs the NSW Home Building Act requires
  • Statutory warranties6 years major defects · 2 years other defects
  • Installed to AS 1562.1 & AS/NZS 3500.3Sheet roofing and roof drainage standards

Three quick steps, about 60 seconds.

Free on-site inspection · Fixed, itemised quote · No pushy sales

Step 1 of 3

What do you need?

Prefer to talk? Call (02) 4005 2903. We only use your details to quote your roof.

Call nowFree quote